Australia's LARGEST model train store

Open 24/7 online

Showroom open 930am to 430pm

Closed Easter long weekend Friday 10th to Monday 13th

(closed Sundays and Public Holidays)

68-72 Old Hume Hwy Mittagong NSW

Call us on 0248712966

Open 24/7 online
Showroom open 930am to 430pm
68-72 Old Hume Hwy Braemar NSW
(Closed Sunday and Public Holidays)
Call us on 0248712966

ESU - 54671 - Power Stay Alive for LokPilot V4

Write a review


Availability: In stock

Only 3 left


54671    PowerPack Mini energy buffer for LokPilot V4.0, LokSound V4.0, LokPilot 5 family and LokSound 5 family, 1F/2.7V


The new ESU PowerPack Mini can be wired to all fourth and fifth generation ESU decoders. It reliably supplies energy to your locomotive when traversing dirty track or long turnout ladders.


With its energy storage (1 Farad capacity) the unit supplies power to all light and motor functions as well as to the sound module. Subject to the energy consumption of your model it may continue to move for up to three seconds.


The PowerPack Mini incorporates an integral charging circuit controlled by the decoder. Therefore, it may be connected even during programming. To avoid an undue load on the booster in case there are several models in the same booster sector, the charging current is limited.


The buffer time can be reduced by means of a CV. This may be useful to assure the correct stopping position ahead of signals showing the “Stop” aspect (red signal).


Although it is considerably smaller than its predecessor, the space requirements of the PowerPack Mini of about 15.7 mm x 9.7 mm x 13 mm must be considered when installing this unit.


A three-pole wire harness connects the PowerPack Mini to the decoder. The wires are already soldered to the PowerPack Mini and must be soldered to the appropriate solder pads of the decoder.


Please note that the PowerPack cannot operate in analogue mode due to technical reasons: Buffering is therefore not possible in analogue mode.


54671 - Power Stay Alive for LokPilot V4 and V5

Write Your Own Review

You're reviewing: ESU - 54671 - Power Stay Alive for LokPilot V4