66841 - Decoder for 6 pin interface (N SCALE)
This is a receiver for all DC locomotives with a current draw up to 1,000 milliamps (motor 1,000 milliamps, lights 200 milliamps). It is suitable for digital locomotives with a 6-pin NEM interface connector.
Can be used universally in Selectrix 1, Selectrix 2, and DCC formats.
Automatic analogue recognition.
Same locomotive address in Selectrix and DCC operation up to locomotive address 99.
7 maximum speeds that can be set.
4 motor impulse variants that can be set.
Automatic load compensation.
Connections for light functions.
Connections for auxiliary functions (Aux1 and Aux2).
Short circuit protection of the motor output.
Programming of additional setting by means of selecting the address "00", such as
Finer gradation of the impulse widths (control variant), direction of travel reverse polarity.
In Selectrix operation:
31 speed levels.
Braking operation with braking diodes.
In DCC operation:
Manual speed level selection 14/28 levels.
Automatic switching to 128 speed levels.
Addresses can be short up to 127 and long up to 9999.
Braking operation with DC voltage and "broadcast mode" braking generators (when analogue recognition is turned off).
Dimensions approximately 14 mm x 9 mm x 2.5 mm / 1/2" x 3/8" x 1/8".